VITA-D-CHLORTM, Neutral
MATERIAL SAFETY DATA SHEET
MSDS Number: V333N
Revision date: 05/24/01
Revision number: 001
24 Hour Emergency Response Telephone: 800-451-8346
Manufacturer:
Integra Chemical Co.
710 Thomas Ave SW
Renton WA 98055
425.277.9244
HAZARD OVERVIEW
HMIS Rating: 0-1-0-B
NPFA: None established
Warning Label: Caution. Use safe chemical
handling practices. Keep container closed. Use with adequate ventilation.
Avoid breathing dust. Avoid contact with skin, eyes, and clothing. Wash
thoroughly after handling.
COMPOSITION/INFORMATION ON INGREDIENTS
Component: Organic salt
ACGIH TLV/TWA: Not listed
OSHA PEL/TWA: Not listed
PHYSICAL DATA
Boiling point: NA
Melting point: decomposes @ 218°C
Specific gravity: NA
Evaporation rate: NA
Vapor pressure: NA
Vapor density: NA
Solubility: 1.3g in 1 ml water @20°C
pH of aqueous solution: 6.5-7.5
Appearance and Odor: Odorless, fine
white crystals.
FIRE AND EXPLOSION DATA
Flash point: NA
Auto-ignition temperature: NA
Flammable limits (% by volume in air):
Upper: NA, Lower: NA
Fire extinguishing media: Water spray,
CO2, dry chemical, or foam
Special firefighting procedures: Use
water to cool nearby containers and structures. Wear full protective equipment,
including suitable respiratory protection.
Unusual fire and explosion hazards:
None identified
HEALTH HAZARD INFORMATION
Effects of overexposure:
Contact: May be irritating
to the eyes.
Ingestion: Ingestion of small
amounts is not likely to produce harmful effects.
Inhalation: Inhalation of large
quantities, or prolonged inhalation, may irritate the respiratory system.
Chronic effects of overexposure:
None identified
Exposure limits: None established
Toxicity data: No information available
Medical conditions aggravated by exposure:
None identified
Target organs: None identified
Reproductive effects: None identified
Carcinogenicity: No listings by NTP,
IARC, or OSHA
EMERGENCY FIRST AID PROCEDURES
Skin contact: Wash with soap and water.
Seek medical attention if irritation develops.
Eye contact: Flush eyes with water
for at least 15 minutes. If irritation persists, seek medical attention.
Inhalation: Remove to fresh air. If
adverse symptoms develop, seek medical attention.
Ingestion: If adverse symptoms develop,
seek medical attention.
REACTIVITY DATA
Stability: Stable
Hazardous polymerization: Will not
occur
Incompatibles: Incompatible with strong
oxidizers.
Decompostion products: Oxides of carbon
(CO, CO2)
Conditions to avoid: Exposure to light,
air, moisture and high temperatures.
SPILL AND DISPOSAL PROCEDURES
Spill and leak procedures: Remove
all ignition sources. Sweep or scoop disposal container in a manner that
minimizes dust dispersion. Wear suitable protective equipment.
Disposal procedures: Dispose in accordance
with all Local, State and Federal regulations.
PROTECTIVE EQUIPMENT
Ventilation: Use adequate general
or local exhaust ventilation to keep fume dust levels as low as possible.
Respiratory protection: None needed
unless use generates annoying or irritating dusts. Use a dust respirator
mask if necessary.
Skin and eye protective equipment:
Safety glasses. Use good chemical handling practices.
STORAGE AND HANDLING PRECAUTIONS
Storage area: General. Store
in a cool, dry, well-ventilated area. Keep away from incompatible materials.
Protect from direct light and minimize contact with air. Protect containers
from physical damage. Keep material dry.
TRANSPORTATION INFORMATION
Material is not regulated via either
ground or air transportation.
REGULATORY INFORMATION
TSCA Inventory: Yes
CERCLA RQ:
SARA EHS TPQ:
SARA 313 Toxic Release de minimus:
SARA hazard categories: Acute: NO;
Chronic: NO; Flammability: NO; Pressure: NO; Reactivity: NO
Clean air act categories: SOCMI: NO;
HAP: NO; Volatile HAP: NO; Organic HAP: NO; Ozone depleting: NO
FDA Recommended Dietary Allowance
for ascorbic acid: 60mg/day
NSF60 Maximum Use: 12mg/L
MSDS Revision History: Original MSDS
NE = Not established; NA = Not applicable or Not available
The information presented above is
offered for informational purposes only. This MSDS, and the associated
product, is intended for use only by technically qualified persons, and
at their own discretion and risk. Since conditions and manner of use are
outside the control of Integra Chemical Company, we make no warranties,
either expressed or implied, and assume no liability in connection with
any use of the information.